× Choosing equipment, install, configure, start using

Tell us about the first stage of operation QSystem. Ask a question about commissioning. Share your experience using the equipment.

QSmartBoardPlugin

Start
Prev
1
Next
End

sanco
Topic Author
Offline
Захожу иногда

8 years 6 months ago - 8 years 6 months ago #2407 by sanco

sanco created the topic: QSmartBoardPlugin

Hello everyone. On QSmartboard source code to set blinking mode code check some condition. Please look the code

final boolean blink = (PrintRecords.getInstance().getRecords().get(i - 1).getState() == CustomerState.STATE_INVITED
                        || PrintRecords.getInstance().getRecords().get(i - 1).getState() == CustomerState.STATE_INVITED);

this snippet code on QBoard.java file. My question is why code check CustomeState.STATE_INVITED two time. Is there any special reason? Why is this condition checked two times?

Last Edit: 8 years 6 months ago by sanco.

Please Log in or Create an account to join the conversation.

Start
Prev
1
Next
End

Time to create page: 0.040 seconds